WoodworkingONLINE.com

You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tips sent to your email address each week! Got to Woodworking Tips.com and sign up today.

Here’s last week’s tip from Woodsmith online editor Ted Raife:

It always breaks my heart when a project gets its first scratch. But I know that even with the best of care, it’s bound to happen. So rather than stew over a minor blemish, I came up with an easy way to make it disappear.

My repair system started with an investment in an assortment of touch-up markers. You can get these from many woodworking and finishing supply companies. My set includes about a dozen different colors and this gives me a good shot at finding a close match to the project. But the trick is finding the best color match without relying on a lucky guess.

To help make a more informed choice, I created a sample sheet on a piece of clear acetate. The sheet contains a small, labeled swatch from each marker. As you see in the photo, I simply hold the sheet up to the project to find a good match. After choosing a marker and performing a quick touchup, the project looks as good as new and I feel a whole lot better.

For more helpful project tips, techniques, and plans, visit PlansNOW.

Good Woodworking,

Ted Raife
Online Editor, Woodsmith

You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tip sent to your email address each week! Go to WoodworkingTips.com and sign up today.

Here’s last week’s tip from ShopNotes online editor Phil Huber:

My workshop shares space with the family car. So it’s important that all of my power tools be portable and take up as little space as possible. So I made the fold-up router table you see here.

I made a simple router table top and attached it to a pair of 2×4’s with screws. Then, after removing the top of an adjustable clamping table, I mounted the router table to the clamping table stand, as shown in the left photo above. The table is firmly supported by the clamping table base.

The nice thing about the table is it can be raised and lowered to match the task at hand. Best of all, I can remove the router and quickly fold the table up to store it against the wall whenever it’s not in use (right photo).

If you’d like to see other router table plans, just go to PlansNOW.

Good Woodworking,

Phil Huber
Online Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tip sent to your email address each week! Go to WoodworkingTips.com and sign up today.Here’s last week’s tip from ShopNotes online editor Phil Huber:

Drilling a centered hole in a dowel can be a challenge. It’s hard to get the drill bit centered and keep the dowel from turning as the hole is drilled. To make it easier, I built the jig shown below.

Build the jig by first drilling a hole the diameter of the dowel in a piece of hardwood. Then just cut a saw kerf through the hole from the end to make a clamp.

Using the jig is simple. Begin by centering the dowel under the bit. To do this, clamp a piece of scrap wood to the table and drill a hole to fit the dowel. Then change out the bit to the size needed.

Next, slip the dowel into the hole in the scrap wood. Then slip the clamping jig over the dowel and squeeze the kerf together with a small clamp. Now you can clamp the jig in place and drill the hole in the center of the dowel.

To learn more essential woodworking tips and techniques, just go to: http://www.plansnow.com/basics.html.

Good Woodworking,

Phil Huber
Online Editor, ShopNotes