Telescoping Drawer Gauge
You can sharpen your woodworking skills with helpful tips and techniques from the editors of Woodsmith and ShopNotes magazines. Get a FREE tip sent to your email address each week! Go to WoodworkingTips.com and sign up today.
Here’s last week’s tip from ShopNotes online editor Phil Huber:
Measuring the width for a drawer bottom can be a challenge. I usually measure several times just to make sure I get it right.Then I made the simple drawer gauge shown in the photo below. Now, I don’t have to worry about the “numbers.” The gauge always shows me the exact distance.
It’s made from two pieces of aluminum angle joined together by a small wood block (see end view below right). The telescoping arms are two pieces of flat aluminum bar stock set side by side. A knurled knob, pressed-in threaded insert, and a penny sets and adjusts the arms.
It’s easy to use the gauge to set up your table saw for the cut. Just slide the arms until each one touches the bottom of the groove in the drawer sides. Then tighten the knob to secure the arms.
Next place the end of one arm against the blade and the other arm against your rip fence. Lock the fence in position and make the cut.
Good Woodworking,
Phil Huber
Online Editor, ShopNotes