Phil Lowe Seminar Review — Part 1
A few editors from Woodsmith magazine had the good fortune to attend an all-day seminar presented by Phil Lowe. The event was sponsored by the Des Moines Woodworkers Association and held at the Woodsmith Store. Here’s what Vince Ancona, Managing Editor of Woodsmith had to say about Phil’s presentation:
“I don’t know if I can sum it up in a couple of paragraphs… most of what I gleaned were random tidbits of information. In general, Phil seems like a very knowledgeable, down-to-earth woodworker. He impressed me as a no-nonsense New England Yankee, who approaches every task at hand in a practical and methodical way. I was as impressed with the way he worked as much as the end result of his efforts.
“I found the slide show to be very inspiring, particularly the photos of projects made by his students. It made me realize that even a seemingly intricate and complex piece of furniture is not so difficult if you just break it down into a series of smaller steps. It also made me realize that there is really no substitute to actually doing something. You can read and watch and listen all you want, but you have to actually get some hands-on practice if you want to master a skill. Phil made a comment about learning how to do something. He used carving rosettes as an example. He said that if you carve one rosette, you will prove to yourself how it is done, and that it can be done. But if you carve 10 rosettes, you will start to get good at it and learn how to do it better and faster.
“I was impressed by how Phil synthesized the use of power tools and hand tools in a way that made complete sense and yielded top-notch results in his work. Again, a lot of this had to do with his no-nonsense approach. He seemed to pick the tool that would give him the best results in the quickest amount of time. Since he does this for a living, I imagine time is money for him, and he isn’t about to waste valuable time setting up a jig or power tool when a hand tool can do the job faster. Conversely, if he has a lot of repetitious work to do, he will invest the time to make a jig for a power tool.”